Pressure drop rate for ducting similar to piping.
S
Sreeraj Kaimalamkunnath
Currently in H2X, there is no pressure drop rate (Pa/m) to show in the result, only pressure drop(Pa) for the whole duct length. We need to calculate them using duct sizer every time.
Log In
C
Conor Jones
Merged in a post:
Pressure drop per metre on ductwork exports
S
Sam Hemingway Hemingway
Can we add an option to show the frictional pressure drop on ductwork exports? Currently we can see the total pressure drop, but nothing for the frictional. Also in the system settings for ductwork - can the pressure drop per metre be changed to Pa/m and not kPa/m. With Kpa/m it is not letting me set anything lower than 1Pa/m. Thanks
C
Conor Jones
Merged in a post:
Ductwork SI Unit for Pressure Loss per metre in Pa/m
E
Estimating
Add SI Unit of Pa/m as an option for ductwork tags, as opposed to stating a calculated total of Pa per section.
C
Conor Jones
Merged in a post:
Pressure Drop Rate as Results Filter for Vent/Duct
C
Conor Jones